You're not going to get much help unless you provide more information than that.
What happens exactly when you power on? Does the A500 work without the Vampire 500 installed? Have you tried another power supply? Have you tried the Vampire in another A500? Has the A500 or power supply been recapped? What other hardware is attached?
Bachotet Sébastien
Posts 5 18 May 2020 11:40
all the elements were transmitted to Masjta by email. I await his return on the forum
Igor Majstorovic (Apollo Team Member) Posts 409 18 May 2020 12:44
Hi, I would put card back to A500 and measure voltage on C3 for 3.3V, if there is no similar voltage there then cause could be short for some reason or some dead component near that voltage regulator.
Bachotet Sébastien
Posts 5 18 May 2020 13:24
C1 = 5 volts C3 = 0 volts (0.320mVolts)
Gunnar von Boehn (Apollo Team Member) Posts 6254 18 May 2020 13:27
Guys I love to see that Igor helps to measure to cards. Thank you Igor.
I would propose you guys meet in IRC,then measuring points and exchanging voltage number will be so much faster and swifter done.