How do I get Pal display on my A2000? I have Super Denise and Super Agnus, when I go to early boot screen on my V500 v2+ I select Pal but when I run Sysinfo it still shows NTSC? Thanks.
Kamelito Loveless
Posts 260 26 Apr 2021 22:12
If you boot into workbench and have an NTSC monitor drivers as your screen mode then this is normal. Try launch sysinfo either from floppy or stop loading to WB or put a PAL monitor driver and select a PAL screen mode.
Carlos Roldan
Posts 46 27 Apr 2021 15:22
Thanks, will try that... but I do have both NTSC and PAL drivers is DEVS:Monitors.
Kamelito Loveless
Posts 260 27 Apr 2021 16:53
Carlos Roldan wrote:
Thanks, will try that... but I do have both NTSC and PAL drivers is DEVS:Monitors.
You can have many but you should set prefs/screenmode to a pal screen resolution.
Documentation about the Vampire hardware
