Matthew Findlay
Posts 15 20 Mar 2019 17:13
| Hey guys, I have had an issue with my 500 V2+ and Coffin54. The only way I was able to get around the issue was to re-flash the coffin image every time it happened. What would happen, is if I was changing any screen parameters, or changing the WB wallpapers, I would get an issue where instead of showing the usual 2400K of RTG memory (with the default 5M allocated) it would instead show only 3-4kb remaining RTG memory but the level of fastmem would be as if the RTG memory was 2400kb (around 107K). This issue would persist even after powering off. The only way I was able to get the RTG mem back to the correct level displayed, was to either change the screen mode from 24-bit to 32-bit and back again, or change the WB wallpaper from "stretch" to "stretch well" and back again. Otherwise, it would display the 2400k for a couple of seconds before going back to showing only 3k. As it is, the issue has not happened since last re-flashing coffin but I also have not been changing about wallpapers or anything this time. I would like to know what the problem was though, just in case it happens again.
|