I can’t find the relevant info to setup the ENC28J60 ethernet module with vampire. I put it all together as specified on apollo page and flashed core to 2.9.
Seems all good but I have never set up a tcp ip stack with drivers etc. Is there a guide or video to watch. I know some form of Roadshow is on my Coffin setup, is that a good one?
It would be nice if an install routine would query me step by step on set up , but I’m an intrepid soul and will do whatever way is necessary.
Retrobrain Johnny
Posts 12 15 Apr 2018 03:20
i used this guide and all worked first try EXTERNAL LINK the roadshow included in coffin is just the demo and only works couple minutes, you have to buy it once you tried it if u wanna stay connected longer periods.
David Wright
Posts 373 15 Apr 2018 04:08
thanks
Eric Gus
Posts 477 15 Apr 2018 04:25
For anyone curious I got it working just fine with Miami (I disabled roadshow) ..
just in the Miami setup you need to change where you have sdnet.device and replace it with v2expeth.device .. (assuming of course you downloaded the latest drivers and copied them into the appropriate places first) and you have the proper ethernet module and have it wired up correctly.
Where can I get v2expeth.device, doesn’t seem to be installed. The hardware is connected to vampire port correctly, Just configuring settings is troublesome.
Mo Retro
Posts 241 15 Apr 2018 17:58
David Wright wrote:
Where can I get v2expeth.device, doesn’t seem to be installed. The hardware is connected to vampire port correctly, Just configuring settings is troublesome.
Documentation about the Vampire hardware
